Start equipment and adjust relative energy level. We advise users to wear goggles.
HR mode:first make test on skin with no hair: if skin turns a little red and a little heat, it means the energy level you set is available, then you can remove hair. SR mode:first make test on skin under jawbone: if kin turns a little red and a little heat, it means the energy level you set is available, then you can treat with face from the bottom up. Make treatment on entire parts; During treatment watch skin's reflection for adjusting in time. Clean treated parts after treatment. Treated skin needs moisturizing and avoid sunshine.
A Adjust energy level from low to high:Don't adjust much for one time. B Test before operation:watch whether the shot is normal before treatment.C Deep color skin shall use low energy level. ALong hair can absorbs more light energy and this may hurt skin. So before hair removal, cut off the longer hair(leave hair 23mm long). BForehead, upper lip, chin -Skin is very thin, so use low energy level; you may feel a little pain during hair removal. CMake the tip fully touch skin to ensure skin absorb enough light hand heat. DDuring HR operation mode, delay between two treatments shall be 30s. Note: If the HR/ SR head can't work normally, pls reset it. Press "+", "-" button, and then press " start" button for 56 seconds, and then you will hear a sound like" wongwong", and after sound" di", you can loose your fingers.
After 23 seconds sounds, and then you can restart it with HR/SR to check it again. Due to the light and screen difference, the item's color maybe slightly different from the pictures.
Please allow 1-2cm differences because of the manual measurement. 1x Host machine & handle.
This item is in the category "Health & Beauty\Shaving & Hair Removal\Electric Shaving & Hair Removal\Laser Hair Removal & IPL". The seller is "auto*home" and is located in this country: CN. This item can be shipped to United States.