Work mode: HR (hair removal) mode, SR (skin rejuvenation) mode. Operating handle Lamp Type: two, one for hair removal, one for skin rejuvenation. Spectral area: 530nm1100nm (SR) / 650nm1100nm (HR). Operating head area: 4.4 cm 1.6 cm. Energy density: 07J / cm2 of.
Pulse number: 2 (HR) / 5 (SR). Level range: 110, step 1.
Power supply: AC 100V-240V, 50Hz / 60Hz in. With Selective pyrolysis and thermal effect principle, IPL Intense Pulsed Light produces a high intensity flash of filtered light from the applicator head, which has been placed in contact with the skin. The energy from the light source is absorbed by the pigment melanin, which is the chromophore, which gives hair its color. The hair rapidly absorbs this filtered light and transfers it to the surrounding cells that in turn are converted into heat.
The heating denatures the cells making them incapable of producing further hair growth. Start equipment and adjust relative energy level. We advise users to wear goggles. HR mode:first make test on skin with no hair: if skin turns a little red and a little heat, it means the energy level you set is available, then you can remove hair. SR mode:first make test on skin under jawbone: if kin turns a little red and a little heat, it means the energy level you set is available, then you can treat with face from the bottom up.Make treatment on entire parts; During treatment watch skin's reflection for adjusting in time. Clean treated parts after treatment.
Treated skin needs moisturizing and avoid sunshine. A Adjust energy level from low to high:Don't adjust much for one time. B Test before operation:watch whether the shot is normal before treatment.C Deep color skin shall use low energy level. ALong hair can absorbs more light energy and this may hurt skin. So before hair removal, cut off the longer hair(leave hair 23mm long).
BForehead, upper lip, chin -Skin is very thin, so use low energy level; you may feel a little pain during hair removal. CMake the tip fully touch skin to ensure skin absorb enough light hand heat.DDuring HR operation mode, delay between two treatments shall be 30s. Note: If the HR/ SR head can't work normally, pls reset it. Press "+", "-" button, and then press " start" button for 56 seconds, and then you will hear a sound like" wongwong", and after sound" di", you can loose your fingers. After 23 seconds sounds, and then you can restart it with HR/SR to check it again. 1x Host machine & handle.
Manual measuring, please allow 1 3mm error, thank you. Due to the difference between different monitors, the picture may not reflect the actual color of the item. We guarantee the style is the same as shown in the picture.
Return item must be unused and in the same condition you received it, in original packaging. If you are not satisfied when you receive your item, Please contact me before you return it. If there is nothing wrong with the item, we will appreciate it and do the same for you. All questions will be replied within 24 working hours. This item is in the category "Health & Beauty\Shaving & Hair Removal\Electric Shaving & Hair Removal\Laser Hair Removal & IPL".
The seller is "motors_parts" and is located in this country: CN. This item can be shipped to United States.